After many trials and tribulations I finally have this thing figured out but not yet fully fixed. 1) I changed out the wiring harness to eliminate va...

8bf320cc5b5e4153c294b4c8549c5b9e. Been away for a bit. Here are some pic's. I have ordered a new wiring harness and I have a new clutch switch f...

Thanks 14724, I will check over the headlight bucket to confirm the connections there and the splicing. I have gathered all the info I can, unless so...

Other info: This is a 1974 R90/6 with no kick start. The neutral switch was replaced with a switch for a 1994. This could have had the transmission c...

Hi Wobbly, I just responded to Murphyam53 about values found with a diode check using a Fluke multi-meter. I think the diode checks out ok. I perform...

Hi Murphyam53 I when I last wrote I had the diode board out of the bike. The soldering in the back is solid and at that time I tested the diode in ...

Hi Bob, If I knew more, I would have more to contribute but I am just learning as I go. I lifted this from another forum from a guy named Roger ...

Thanks! very much appreciated!

I am checking the neutral light diode on the circuit board in the headlight bucket of my R90/6. It is not passing continuity in one direction but has ...

This helps me immensely! First, It's good to be sorted out with the improper use of dielectric grease. I thought it was used to enhance electrical con...

Hi Wobbly, Thank you for the info. This helps me further conceptualize this system and organize my approach to trouble shooting. The bike has been ...

You make a good point here! I am spending weekends in the garage getting ready. JB weld was the way to go for sure as the faring material seems like a...