FORUM

Richard W
Richard W
@wobbly
Member
Joined: 03/05/2016 16:59
Last seen: 11/26/2024 05:54
Topics: 89 / Replies: 2504
Reply
RE: Fusing a 1971 R75/5

For the most part I agree with Donald's writeup. But allow me to add some thoughts.... 1. Type Of Fuse I strongly disagree with the suggested cyli...

3 years ago
Forum
Reply
RE: Starter Relay Testing

• The Starter Relay simply routes low current 12VDC to the starter motor. You can unplug the small wire at the starter motor, affix a 12V mechanic's t...

3 years ago
Forum
Reply
RE: Screw For Instrument Cluster

► If you use the OEM type screw in that position, then you'll want to first lube it with silicone spray. To install, first turn it backwards (LH) unti...

3 years ago
Reply
RE: Parts Advice Wanted - Shocks for dual shock /6 street use

This is a message about TIRES in a thread about SHOCKS. Black HTML characters are expensive, but the Club can afford it. We're going to move this to i...

3 years ago
Reply
RE: Air Screw-In Raises Idle

When working on carbs I find it really helps to get into the correct "mindset" or understanding. These thoughts might help... ► The carb is part of ...

3 years ago
Reply
RE: Air Screw-In Raises Idle

Thoughts and suggestions.... New air filter from where ? If the bike has over 50K miles then you need new needle jets, regardless of what you can...

3 years ago
Reply
RE: Air Screw-In Raises Idle

PS.... The correct spark plug for this bike is NGK BP7ES. Pay no attention to the NGK plug chart. It is wrong. NGK will soon stop making this p...

3 years ago
Reply
RE: Air Screw-In Raises Idle

Welcome Aboard ! Some thoughts and comments (in no particular order).... There are 2 screws: Idle Mixture and Idle Speed. Idle Mixture starts at...

3 years ago
Reply
RE: Crankcase breather valve

I can't talk to the Brillo. No experience in that area. However, I'm all in for... Making sure the tiny drain hole is open in the "recovery well...

3 years ago
Forum
Reply
RE: Crankcase breather valve

So in the first paragraph you are discussing what is clearly off-road riding, complete with stream crossings. If you do the breather re-route as dis...

3 years ago
Forum
Reply
RE: 77 r100/7 front brake master cylinder issues

Besides the use of stainless steel brake lines, my recommendations also included the EBC full floating brake discs, which when matched with new EBC pa...

3 years ago
Forum
Reply
RE: Valve adjustment R90

All he did was re-pack the ball bearings (or replace the bearings). We've discussed this situation before in these pages. The OEM grease simply gets s...

3 years ago
Forum
Reply
RE: Welding on airhead frame???

Jim - 1. TIG welding should be just fine. Move all the plastic components away. The fuel lines will be right there, so drop the 2 float bowls, and h...

3 years ago
Forum
Reply
RE: Ignition switch woes 78 R80/7

It's the first thing I do with a new to me bike. (It's nothing short of a miracle on a British bike !) And every time I replace a voltage regulator, s...

3 years ago
Reply
RE: Oil cooler. to fill or not to fill?

@bruce-suehr You're certainly welcome, sir.

3 years ago
Page 47 / 173

Advertisement

Scroll to top