FORUM

Richard W
Richard W
@wobbly
Member
Joined: 03/05/2016 16:59
Last seen: 11/23/2024 09:41
Topics: 89 / Replies: 2504
Reply
RE: Stored '83 R100 RS needs some restorative TLC

Yes, the max life on DOT4 brake fluid is 5 years, or crud starts to appear. This is why BMW recommends replacing your DOT4 every year. A lot of owners...

1 year ago
Reply
RE: Running rough at 3000 to 4000 rpm

Allan - What say we stop yapping and start focusing on your problem? Despite all the rambling, your issue is most likely fuel/ carb related. BUT, ...

1 year ago
Forum
Reply
RE: How to test 1982 R100RT headlight relay and left combination headlight switch

• Remote fuses for the RT and RS was considered an "upgrade" back in the 1980's. In fact my 1979 RT came with both holders remoted to the a location n...

1 year ago
Reply
RE: Running rough at 3000 to 4000 rpm

Here's the difference, my friend... • Any good mechanic can set the carb balance by ear at idle. But you also need to set the balance by cable pull ...

1 year ago
Forum
Reply
RE: Running rough at 3000 to 4000 rpm

I will. Based on Allan's comment about the shop setting the carb balance by ear, either 1) the shop does not own a carb balancing tool, or 2) they don...

1 year ago
Forum
Reply
RE: How to test 1982 R100RT headlight relay and left combination headlight switch

I didn't say the fuse was bad. In my experience these type fuses simply make VERY poor electrical contact. That's why ALL the German cars and motorcyc...

1 year ago
Reply
RE: How to test 1982 R100RT headlight relay and left combination headlight switch

First look at the 2 fuses. REPLACE the entire OEM fuse box with modern, flat-pack fuse holders. Like below. Then install two 10A fuses.

1 year ago
Reply
RE: Running rough at 3000 to 4000 rpm

Welcome. Very nice bike ! Some ideas... • The number one issue is ALWAYS fuel related, especially when combined with storage. So your man installed ...

1 year ago
Forum
Reply
RE: New member in Williamsburg, VA

• For small engines (mowers, chain saws, blowers, etc.) I treat the "fill can" with StarTron. If the stabilizer is infused throughout the entire fuel ...

1 year ago
Reply
RE: New member in Williamsburg, VA

• Do you mean plug wires ? Those MUST be metal-core wires, and not the resistive core wires cars use. • Those plug wires are always replaced with th...

1 year ago
Reply
1 year ago
Forum
Topic
Replies: 10
Views: 521
Reply
RE: New member in Williamsburg, VA

Welcome ! Some tips to get you started... • It would be better to simply drain and refill the engine oil until you fully understand about the "whi...

1 year ago
Reply
RE: First time replacing fuel lines on R100RS - questions...

• On the older models with the aluminum air box, both halves of the air box must be removed. • On the newer models with the plastic air box, the ent...

1 year ago
Reply
RE: New Member

Next to never are the bearings or carb parts ever "bad". That is to say unusable. The Airhead is not from the age of the "disposable culture". Most of...

1 year ago
Page 11 / 173

Advertisement

Scroll to top