FORUM

Richard W
Richard W
@wobbly
Member
Joined: 03/05/2016 16:59
Last seen: 11/20/2024 06:43
Topics: 89 / Replies: 2503
Reply
'83 R100RS: Crankcase breather

There are multiple specially formed rubber hoses which route the breather into the return cover and then from the return cover to one or more of the c...

5 years ago
Reply
'78 R100: Steering Damper question

Welcome Aboard ! First of all, let's clarify you are talking about the Steering Damper, and not the dampers inside the front forks or rear shocks. ...

5 years ago
Reply
'78 R100: Hella bar end signals on /7 switch gear

Robert - Welcome Aboard I haven't done that, but I can see 2 issues that might trip you up.... • The lamps are going to need an electrical Ret...

5 years ago
Forum
Reply
Airhead Tire Preferences

Since the leak is very likely to be at the valve stem, either because of a poor core or ripped stem, and because the "stop leak" doesn't reach there.....

5 years ago
Forum
Reply
Airhead Tire Preferences

Sounds "iffy". Are you sure you're not loosing that when you go to measure ? If so, I'd replace the tube. I could believe 3-4 psi per month.

5 years ago
Forum
Reply
'74 R75/6: Help teasing out a speedo / possible gear ratio issue

I just did a test ride, and the odometer is reading bang on accurate. Hey, that's great ! Now I’ve got to look more into what you’re talking ab...

5 years ago
Reply
Airhead Tire Preferences

I went through several sets of Bridgestone S11 Spitfires, and upped that the last time to Bridgestone Battlax (the next better tire in their lineup). ...

5 years ago
Forum
Reply
'74 R75/6: Help teasing out a speedo / possible gear ratio issue

Welcome Aboard ! I believe you may be looking in the wrong place. Map out a 10 mile loop with Google Maps or some similar GPS type mapping system. ...

5 years ago
Reply
'77 R75 /7: I think my timing is way off

You should remove the front engine cover, get all the tools to set the ignition timing in place, and put a box fan blowing on the engine. Then cra...

5 years ago
Reply
Leaking Carbs - R90/6 '76

Extract the float pivot pin from the carb body from the knurled end. Replace both the float and the float needle. Reinstall the pivot pin with the new...

5 years ago
Forum
Reply
Bean can rebuild

Agree with Scot. Newer EI products now store the advance curve in software, which entirely removes all the need for mechanical advance mechanisms. The...

5 years ago
Forum
Reply
'71 R75/5: Removing and Installing Carbs

Please keep your comments pertinent to the Club's focus on Airheads. Thank you.

5 years ago
Forum
Reply
5 years ago
Reply
'74 R90/6: left cylinder after or back firing above 3k rpm

I checked the exhaust system yesterday and couldn't find any holes. These are not typically rust holes or some such, but rather leaky pipe-to-pipe j...

5 years ago
Reply
'71 R75/5: Removing and Installing Carbs

I've got them running well when warm but having trouble with cold starting. The typical Airhead requires full choke to start, even on a warm day. Do...

5 years ago
Forum
Page 77 / 173

Advertisement

Scroll to top