FORUM

Richard W
Richard W
@wobbly
Member
Joined: 03/05/2016 16:59
Last seen: 11/19/2024 06:14
Topics: 89 / Replies: 2503
Reply
'78 R80/7: Get running again questions

I'm reviewing this (now) 5-page thread. You've never told us the year of your bike. It looks to be a '78 or '79 model, but a year would help. Than...

4 years ago
Reply
'78 R80/7: Get running again questions

► It is critical only in the sense that failure to do so is going to cost you $400 to $500 to correct, and become one more road block to finally getti...

4 years ago
Reply
1980 R100T Left Perch Loose

• Those are correct 22mm bars then. • Correct. There is a single, black SHCS from the front. It requires a 4mm Allen hex key. It's the same for bot...

4 years ago
Forum
Reply
Gas tank replacement

I have seen the classic 60's Triumph tanks made in India and they are very, very nice. I did not buy one, and a US-based seller was selling those on E...

4 years ago
Forum
Reply
'78 R80/7: Get running again questions

- As far as the starter relay goes - I ordered the $6.50 part you suggested ... is it a standard-type relay? Do you mean that I don’t necessarily need...

4 years ago
Reply
Balancing the rear wheel R100GSPD

That's exactly what you need. You also need to know, new tires are marked (one side only) with a paint dot at the lightest part of the tire. The va...

4 years ago
Forum
Reply
1980 R100T Left Perch Loose

Could be 2 issues... • First of all, what size are your bars ? The OEM bars are 22mm (0.866"), but a lot of the aftermarket bars are 7/8 inch (0.87...

4 years ago
Forum
Reply
'78 R80/7: Get running again questions

• You never talked much about what you found under the tank. I had advised you wash the electrics to remove all the spilled and leaked DOT4 brake flui...

4 years ago
Reply
'83 R100RT: Front oil seal

Welcome Aboard ! It involves removal of the front and inner engine covers, a repair accurately described in every shop manual. So I'll pass on a fu...

4 years ago
Forum
Reply
New Member - New to Motorcycles and to my 1975/76 R90/6

And please put your general location in your profile so that other members can help you. Has someone looked at the bike to make sure it's safe to ...

4 years ago
Reply
New Member - New to Motorcycles and to my 1975/76 R90/6

Greg - I'll do everything I can to help you, but obviously the "teach by wire", however good it might be for disease prevention, precludes a LOT of t...

4 years ago
Reply
New Member - New to Motorcycles and to my 1975/76 R90/6

Welcome Aboard ! Hi Greg ! ► There is a key position provided for emergency parking in which the ignition is OFF, but the tail lamp is ON. That ...

4 years ago
Reply
‘83 R100CS weird clunking noise while coasting

Let's get back to the OP's issue.

4 years ago
Reply
LED Headlight Recommendations

This topic is thoroughly covered HERE

4 years ago
Reply
Balancing the rear wheel R100GSPD

Yes, like Scot said. A special axle with inward facing cones is used to "chuck up" the wheel. Then when everything is tight, that axle sets on 2 new b...

4 years ago
Forum
Page 67 / 173

Advertisement

Scroll to top