Well, one thing is for sure.... the older schematics leave a lot to be desired as far as clarity. Especially once you get inside the gauge set. And se...

Mac Performance sells a nice set, with a good note and a price much lower than OEM. But their web page seems to be down at the moment. Dennis Kirk and...

I've also installed that same LED rear light panel on several Airheads from 1979 to 1988, all without issue. Some ideas... • It's easy enough to tes...

Joe - It simply means your starter motor needs some attention. The yellow circle will automatically go away when you get that repair task completed....

You'll like it. They make lifetime spokes.

@gpopovichcastlerockwinery-com They don't list them for 21", but they do list them for 19". That means they can certainly make them at very little ad...

@sebascodegan If the drive cable and remainder of the Speedometer are good, then I will assume the Odometer still works OK.

• Chrome won't stick to steel during the plating process, so the chrome layer is always preceded by a thin layer of copper plate. That's standard indu...

You are having bendix issues. The bendix is the assembly on the end of the starter motor shaft that engages the ring gear on the flywheel. When the st...

OK then, in most analog speedos and tachs, the rotating cable drives a magnet. The magnet spins inside a co-axially located steel cup. The cup and mag...

I have worked on 3 or 4 sets of speedometers for the /6 and later side-by-side gauge sets.... but one of my other hobbies (when I'm not out in my Roll...

• No thanks needed, I'm simply here to help. • I was able to secure larger jets by fishing around in the Max BMW parts fiche within other models. Be...

@red-horse Higher number, larger jet.

My money is on 1) mis-alignment of the friction plate, or 2) friction plate installed backwards. NOTE: "Mis-alignment" is not a beauty contest winne...

Just a guess.... The rocker arms may have not allowed the inlet valve to close all the way, or as quickly as needed, thus allowing the valve to stay s...