► In hindsight, the first thing to do is put an oil pressure gauge on the bike and ride it until the oil is warmed. Then you should get a realistic pi...

• First of all, you'll need to hold the camshaft in your hands to do the inspection. Peering through the cylinder hole is no way to inspect a part. Wh...

Welcome ! ► Please check that your RT's front snowflake wheel has the reinforcing webs at the hub. Earlier wheels without reinforcement webs were kn...

1. The date stamp will be on the RH side. 2. The first thing to do on an RT that old is make sure your bike is running the reinforced wheel, ...

Glad you got it sorted.

Here's where you can get any type/size/material you want...

• You can barely see them, but 3 links were given in my post: starter relay, LED HL bulb, and replacement VR. • /7 starter relays are now under $...

► Agreed. You must have the correct lengths statically, before re-assembly starts. That is, with the carb in position, the elbow should look like the ...

► Did you "chock the crank" before disassembling the clutch? That's a VERY important first step. ► Did you mark the relative positions of the piece...

My theory was to do the prep work in my shop where I had all the tools and could do the work with fans and lights vs. side of the road. When I ride, I...

Welcome ! Unlike the Brit bikes you've been riding, pieces on the R75 are not a mirror image. Stand on the rider pegs and look down. You'll see that...

You may have the rack intended for the SWB early bikes or single-sided late-model bikes. Come on by, I have a huge selection of rear racks, both round...

Or, you can locate what's known as a Reynold's "Ride Off" stand. If you have the proper size tires, then the bike ends up resting on four points while...

• The thumb screw is the large screw shown with the spring.

Simple enough ! ► You want to do this after a complete tune-up. Especially important is strobe timing the ignition to the Full Ignition Advance mark...