FORUM

Richard W
Richard W
@wobbly
Member
Joined: 03/05/2016 17:59
Last seen: 07/01/2025 07:31
Topics: 91 / Replies: 2567
Topic
Replies: 11
Views: 1153
Reply
Let's all meet here.....................................................

Not expected to wear facial masks ? Ha ! Half the attendees in Sturgis don't wear clothes ! đŸ˜†

5 years ago
Reply
Introduction Eric M

Aww, Jeez. I didn't need to see that this morning !! That's really beautiful. Congrats.

5 years ago
Reply
Introduction Eric M

3 classic Mini Coopers !! Oh my that brings back some memories. I had a 1275, and then later a 998. What FUN cars !! I'm in north Georgia. I was a ...

5 years ago
Reply
HIGH SPEED WOBBLE

I'll be done by tomorrow instead of sometime next week (or year). Oh no you won't !! It will take you a week just to find the correct grease ! Y...

5 years ago
Reply
'76 R75/6: Points don't open

I personally do not use sandpaper on the points. I didn't say anything about "sand paper", which is only found in a wood working shop. I said emery....

5 years ago
Reply
HIGH SPEED WOBBLE

Determining the need for steering head service is simple. And usually done at the same time as wheel bearing check because the wheel has to be lofted....

5 years ago
Reply
Re: 1980 R100RT Instrument lights

Oil pressure is Yellow for some strange reason. The upper Red is low front brake fluid reservoir level, and the lower Red is failed alternator output....

5 years ago
Reply
1975 R60/6 Front wheel noise stopped by lightly applying front brake lever

Brake noises typically only appear when the brakes are applied. I'd be checking wheel bearings first. â–º To test wheel bearings, put the bike on th...

5 years ago
Reply
'71 R75/5: Installing cylinder studs

Glad to help. And hope you found it informative as well as useful.

5 years ago
Forum
Reply
Timing Covers & Oil Coolers

My experience on the road models ('81 and '88) is that the Oil Cooler is mounted to the frame with a single 8mm bolt at top center. Using a 13mm wrenc...

5 years ago
Forum
Reply
Timing RPM

I've got a kit sitting on the shelf for my Trail 90 as I write this, waiting for a Round Tuit to finish the job. You've got a Trail 90 ??? My admira...

5 years ago
Forum
Reply
Seibenrock Kit R45 and carbs

I am not really well versed in this or these kits. Your answer depends upon how big you want to go. If you want to go to 650cc you'd be OK. If you wan...

5 years ago
Reply
Introduction Eric M

Welcome Aboard ! Some thoughts... • Let me underscore the need to visit a Tech Day anywhere near you. You'll get a jump start on your Airhead trai...

5 years ago
Reply
'76 R75/6: Points don't open

Hey, that's great news. Some suggestions... • The correct points gap is set when the points are riding on the highest part of the ignition cam lobe...

5 years ago
Page 69 / 178

Advertisement

Scroll to top