I'm sorry, I'm having a hard time following you. Could you please post some photos ?

• You're certainly welcome. • This is the power of "community", which is why you join a club like this to begin with ! • This site doesn't "host" ...

First Thing: If your pet cock is the one with the plastic nib on the bottom to connect the fuel hose, then I highly suggest you start casting around f...

One last idea... Have you looked at the condition of the 3-pin ivory-colored connector coming off the bean can ? If there is any crazing, cracking, cr...

• There are ignition analyzers you can use. I've seen hand-held tubes about the size of your index finger to can hold against the plug wire and a smal...

Welcome Aboard ! First thing you'll want to do is contact your local Airhead Club director, what we call an "Air Marshal". Get on his contact list s...

The best way isn't always the easiest looking way. That's all I know.

The tube is pressed into the cyl head, making very good thermal contact. So first off, there's the issue of applying enough heat. Secondly, when you d...

In the old days, when this bike was new, tapping the collars down to cinch-up the PRT oil seal was a common mechanic's trick. It's highly conceivable ...

What does the weep hole say ? Nothing told us about the previous work. That might depend on the type of oil. At a minimum, I would try ...

Welcome Aboard ! Eye popping photo! Wow !! First thing you'll want to do is contact your local Airhead Club director, what we call an "Air Marshal...

Since this has occurred several times, there's no evidence that it will change its course in the future. A) The friction plate almost has to be of a p...

That will NOT be an "apples-to-apples" comparison. You won't be telling yourself anything useful. First you should rebuild your master cylinder, the...

This is a great mod. The view to the rear is 100% improved and these low rise black mirrors do the trick without completely ruining the original "look...

And that's the deal, the OEM greases has oxidized and turned to a paste so thick that the motor can't turn. The bearings don't go "bad", they don't ha...