FORUM

John Bernetich
John Bernetich
@johnb
Eminent Member
Joined: 08/24/2020 18:04
Last seen: 12/11/2020 17:49
Topics: 11 / Replies: 15
Reply
Front brake light switch

Right on !I Disassembled the front master cylinder fully expecting a rusty mess that was preventing the piston to fully extend. The bore was clean an...

5 years ago
Forum
Topic
Forum
Replies: 2
Views: 789
Reply
'74 R90s Clock Stopped Working

Hi group I had a simular problem with my 82 R100 RT clock not working. I wanted to keep the original clock on the bike and after much searching I fo...

5 years ago
Reply
HIGH SPEED FUEL STARVATION?

Wobbly Regarding question #3. I have owned the bike for two years. When I purchased the bike from the PO it needed a lot of mechanical work but it ...

5 years ago
Reply
HIGH SPEED FUEL STARVATION?

Hi Wobbly Air box and filter checked out OK, manometer plugs are in place, rubber hoses to and from carbs are fine. Fuel filters are clear and allo...

5 years ago
Reply
HIGH SPEED FUEL STARVATION?

OK - I measured the gas flow through the fuel filters and it met or exceeded the criteria for fuel flow. Also, I followed the instructions for the...

5 years ago
Reply
HIGH SPEED FUEL STARVATION?

Thanks Scott I will start with the easiest and progress to the carb rebuild if necessary. I will let you know what I find.

5 years ago
Topic
Replies: 8
Views: 2397
Topic
Replies: 1
Views: 1985
Reply
needle tip grease gun

Thanks Harry. I knew that someone would have the answer. Looks like Amazon will get the nod. JB

6 years ago
Topic
Replies: 3
Views: 2876
Reply
bmw clock disassembly

Wobbly I am not very literate with the computer link stuff ( I am an airhead remember) but the best I can do follows. In your search box type "flic...

6 years ago
Forum
Reply
bmw clock disassembly

Hi Wobbly I found an answer to my bezel removal problem. I Googled bmw motorcycle clock repair". I found a Flicker site titled "BMW motorcycle cloc...

6 years ago
Forum
Reply
signal lights cause voltmeter to swing

Thanks Murphy I will open up the bucket this winter when I am performing PM and give everything a through cleaning.

6 years ago
Topic
Forum
Replies: 7
Views: 5930
Page 1 / 2

Advertisement

Scroll to top