Rear wheel back on. Tried the driveway test run - still the same chattery clanky bad gear noises upon clutch engagement! At my wits end, pulling my ...

@wobbly - stretch bolts for driveshaft to xm output have been re-checked and are tight. I did just now run the engine and engaged the clutch through...

I was also thinking about running the engine and engaging the clutch with the rear wheel off and bike supported, therefore no real load, just spinning...

Yes, crankshaft was well secured for any manipulations of the flywheel. Maybe I should rephrase my question out there to the airheads: has anyone i...

Yes, the bike did want to move with the clutch being engaged and the clunking. Afterwards, I did check the 4 stretch bolts holding the drive shaft to...

Thanks Wobbly

Thanks Scott