FORUM

bob hardacker
bob hardacker
@bobh
Active Member
Joined: 08/24/2020 17:41
Last seen: 08/04/2024 12:04
Topics: 1 / Replies: 6
Reply
RE: bmw clock disassembly

an alternate method to using a flat screwdriver is to take an old 'church key', grind down the sharp end ~1/8", then "sharpen" the left over tip a bit...

4 years ago
Forum
Reply
Piston Ring End Gap from Snowbum's site

yep, like all 'tech' experts, a grain (or shaker) of salt is req'd. i find that reading as many different takes on the same topic when combined wit...

7 years ago
Forum
Reply
Piston Ring End Gap from Snowbum's site

Actually his formula almost exactly duplicated the BMW spec 0.012" vs 0.0124". the added remark that the BMW min spec should be avoided is what thr...

7 years ago
Forum
Reply
Piston Ring End Gap from Snowbum's site

sure, makes sense. I get not going under the BMW min spec, it was the part of the remark that suggested even the min spec was too tight although the ...

7 years ago
Forum
Reply
Piston Ring End Gap from Snowbum's site

Hi Wobbly, You got to the crux of my question with your file suggestion as to how to keep the ring ends truly parallel. This is what had been esca...

7 years ago
Forum
Reply
Piston Ring End Gap from Snowbum's site

understood. I used that technique to determine the ring gap after honing. The real question is how to keep the 'filed' end perfectly square.

7 years ago
Forum
Topic
Forum
Replies: 11
Views: 10744

Advertisement

Scroll to top