Perfect, thank you so much! I'm going to order the screw kit.

Thank you for your reply. I just measured my bars with a digital caliber, 21.97mm. Ok, after taking the switch part off my perch I found a large...

Just another option. EME has a rebuilt bean can exchange program, . The cost is $280, but they refund you $100 when you send them your old bean-c...

I have the same problem with one of the my carbs. on my 1980 R100T. Both of my carbs were blasted-n-rebuilt by BING USA. I contacted them, can't rem...

I have the same problem with one of the my carbs. on my 1980 R100T. Both of my carbs were blasted-n-rebuilt by BING USA. I contacted them, can't rem...

* Pre-made 5K NGK wires from Motorrad Elecktrik. * As far as the spark plugs go, there-in lies the problem. Different websites, different retaile...

My cables and caps were already assembled when I bought them. I measured from the connector inside the cap to the connector on the other end, 5K! ...

Thanks for the reply Wobbly, I appreciate your suggestions. Actually I've done a lot of work on my bike, yes, turned my own wrenches. My bike was ru...

First-off, I have a /7 which is wired somewhat different than a /6. But the concepts are the similar. I took a look at the wiring diagram for you...

I found this printout years ago(see attachment). This tool is for torquing the drive shaft bolts. Not sure if it's for the bolts you're talking abou...