FORUM

mark von aldenbruck
mark von aldenbruck
@blind-lemon-pie
Active Member
Joined: 08/24/2020 18:18
Last seen: 06/17/2023 04:27
Topics: 4 / Replies: 7
Topic
4 years ago
Replies: 1
Views: 858
Reply
R80ST fork damper rod spinning help

I got it! Thank you (all) for all of the advice. It took a combination of many tips, here is what I did. Front wheel off, with center stand secured....

5 years ago
Forum
Reply
R80ST fork damper rod spinning help

Good morning Scot, the damper rod bolt must have thread locker or corrosion, it turns easy with the internals spinning now. I will try the heat toda...

5 years ago
Forum
Reply
R80ST fork damper rod spinning help

Thank you James for the tips. If the front wheel is installed the axle blocks access to the damper rod bolts at the bottom of the fork leg. I have dra...

5 years ago
Forum
Topic
Forum
Replies: 8
Views: 1155
Reply
Kuh Thunk! 1970 R75/5 Clutch flywheel transmission

Awesome, thank you Scot for moving my post and advice. I will try prying the speedo cable up. Regards, Mark.

6 years ago
Reply
Kuh Thunk! 1970 R75/5 Clutch flywheel transmission

I drained the transmission today in preparation for removing it and found a gear tooth 13mm in width. I removed the transmission breather bolt that ho...

6 years ago
Reply
Kuh Thunk! 1970 R75/5 Clutch flywheel transmission

Thank you for the suggestion. I turned the engine over slowly at the alternator and looked into the timing hole and the outside of the flywheel seems ...

6 years ago
Reply
low compression

Thank you wobbly, the engine is not rebuilt, so braking in the engine is not needed. i adjusted the valves as per your wonderful tutorial, insta...

6 years ago
Topic
6 years ago
Replies: 3
Views: 3210

Advertisement

Scroll to top