Wild A Guess-torque of engine mounting bolts. I don't have spec on anything that new.

I just did this with old tires-lots of tread, but too old. I went down once with a good looking tire which was maybe 6 years old and should not have t...

Is there a new editor?

According to Snowbum (bmwmotorcycletech.info), until around 81, the collars were not braised and there was a tool to drive them tighter against the se...

Welcome from about as far away as you can get from WA, the GA coast. Great picture. Bob

If it were me, I would, as suggested above, remove all severed wires from the circuit board. Next turn on ignition switch. Make certain headlight come...

SC Airmarshal Jim Zellmer did mine. Jim@ka0vsl.com. He bought Oak's tooling and got training from him. Bob

My experience with oil levels also, James. Once at the half way mark, the oil level stays the same until next oil change except when I had a bad oil l...

Airhead tent at the RA National in Waynesville, NC and many more, information will be in Airmail. Unless of course there is a shutdown for Covid.

If both are flashing with the ignition on and turn blinker switch off, the problem is not the relay. With the switch off there should not be a connect...

The seats are heat shrunk into the heads and certainly the seat will come out again likely with costly consequences. There are numerous people who can...

Les Welcome to the airhead world. Looks like a good start, but beware these things can be addictive-some folks end up owning seveal. Bob

Valeo on my oilhead certainly had magnets come unglued. Bob

Another source of parts is Rubber Chicken Racing which has an add on this page. He knows airheads. Bob

Try randybeemer@comcast dot net