Last seen: 12/23/2024 04:24
Correct, I'll be working to get out on a few rides as soon as I can. It's a bit tough with my current work schedule but I'll give it a go. I know my s...
Yeah...simple. Oh yeah, that's me! đŸ˜›
Yay! I think I got it! I finally got out for a test run today and when I got back the battery was charged just fine, not like before when it would run...
Hopefully I have the 3 wires back in the same order if it makes any difference. I was going to go for a test ride but realized I didn't have a helmet ...
Of course taking the grinder to the stator wires clipped them. Now I need to solder on new extensions for 2 of them. At least the brushes are in and d...
Good to know.
Of course whatever solder they used is crazy hard, none of my soldering irons will melt it. I'm going to bring in my grinder to take them down.
When I opened it up one of the brushes was pretty much gone so I'm confidant that was the problem. Now I need to get the soldering iron out to remove ...
The brushed arrived, I'll get them installed and see where I'm at.
Thanks for the offer but I ended up ordering some from Bob's. I needed a couple of the rubber plugs the go in the engine case where you look for TDC. ...
Ok, thanks for that little guide to the gauges. I'm hoping I don't have to dig into that. Any thoughts on the best place to buy brushes?
All of the terminals are good, I checked that when I was trying to fit a new battery. I'm not sure the "gen" light is coming in, there are a couple of...