Wasn't sure what it's duty was. Mine is about 1/2 in. A little contact cement and some foam then

Thanks for the nooxid paste idea. Ordered some just now. Bad ground makes sense. I have 3 lights on solid when ignition is turned on, orange (oil P) ,...

1978 R100S. I don't get a soft glow at all. They work great except when I turn off the right signal, the dash light stays on, solid. The blinkers don'...

Well, after launching five BB's into the stratosphere of my garage, I finally got the switch back together. So that's cool. But my main issue that I t...

Finally, after launching 5- 1/8" bb's into the stratosphere, it just slid into place. I apparently have 2 left thumbs. But all good and normalish...

You're right w the 3 mm but the 1/8 falls right in. It's just pushing the spring loaded ball into the hole that will launch it.

I don't have a template on how to reassemble. I'm assuming the wavy washer goes on first, next to the switch base. Then the notched contact washer th...

Thanks. The little spring peeking out of the switch made me just set the whole thing down and send an sis. I'll report my success or failure.

Just installed a H4 from Cyron. Very easy to install and very bright. Lost the focus line (whatever that's called) that is on the original H4, so it's...

New tank rubber supports are only $14 from the dealer. They said the rubber can shrink over the years. Maybe so, it has been 50yrs. I'll report back i...

Just ordered. Thanks for sharing your knowledge

I put on one set of washers and it's mostly gone. Another set and it's gone. So that's cool. It's certainly odd that I needed to do that. It's pretty ...

I want to thank you for all your help. My front shocks are now very quiet. Although, when I pull it up on the centerstand there's a looseness type clu...