
Last seen: 03/09/2025 05:42
Yes, you remove that screw, and the needle will fall out when you turn it upside down. That particular needle uses the tiny c-clip to position it. L...
Hey Scott, nice to see the update and news. The left plug looks fine, how about a picture of the right? Yes, some oil mist could cause a bit mor...
As Richard says, BMW keeps the wire colors the same for the same functions during year changes. And to boot, for a number of years switches interchan...
Very good news! As Richard says, there are V meters on the web used and unlike the original clocks, they are I find pretty reasonable in price. Al...
LOL, a tip off is if the buzzing noise is coming from under the gas tank, it is most likely the relay coil if failing internally. Then again since...
It's been a long time since I tried to take a similar switch apart, I didn't have any luck. I found that some things are easy to take apart but unles...
Are you asking about taking the guts out of the old switch to replace with a new cover? Or are you having an issue with just removing the switch from...
David, my friend at his airhead shop had the same thing happen to a customer who had changed his own points. The bike acted up, the customer got fed ...
I put the cart before the horse, I wrote my reply before listening to the videos. I would guess, the starter relay is bad just from listening. Stil...
I had a similar thing happen. You say you did electrical upgrades, recheck your work. Not only the positive connections but ground connections as we...
Thanks for keeping us updated, I am glad you are making progress. St.
I have been thinking about what I wrote earlier and want to clarify a bit. While bleeding brakes it is essential the bleeder is only open while pres...
Richard makes a good point regarding replacing the brake lines. While the bike may have low miles, it is old and the lines could be shot. Then ...
As a survivor of three accidents, I am a AGAT guy, full face helmet, back pad the whole nine yards, put on just for a short ride. LOL, I may not be g...