If you are not implying it is the fuse, why in the world are you writing about changing the fuses and holders? 5499, are you writing the fuses on yo...

Allen, my local restoration/repair shop owner turned down two bikes this past fall for restoration due to the cost versus worth of the bike when finis...

LOL, Sorry Allan, I thought you had not torn apart the front end yet. One of the deficiencies of communication of forums is lack of communication. L...

Yes, your write up about the action you are seeing with the yellow white wire makes sense. The low beam as far as I know on your bike unless it has t...

The green wire is a switched hot wire. You should get a voltage reading at pin 56 the white wire at the circuit board for high beam. The white wire e...

So I have been thinking, LOL a sometimes bad thing, but it is raining. Have you checked the color of the spark plugs after a long ride? They should ...

Assuming the shop did a proper rebuild on your carbs, I am not going to insult them by implying otherwise, I would look for an ignition problem. Whil...

So yes, you can check things with a probe and multi meter. NO, you don't have to fool around changing fuses from factory to OM. Anytime you chang...

Glad you found the write ups. Honestly Dave, I myself have never seen one of these plugs leak. LOL, so I am afraid I can't give you the first hand ...

Check with Kurt at the BMWMOA forum, seems there was a thread there awhile back. I tried to find it but couldn't, he may have better luck. Also Sno...

I have to add, I haven't seen this set up before, LOL, I guess nothing this new has come into my friend's shop so, I can see why there is an issue of ...

Maybe I should have not answered. I am NOT fully aware of the added EPA "stuff" they added to the bike in question. Sounds like a more complex job ...

Well for some reason the Airheads forum won't let me copy and paste the website for the BMWMOA forum post. The date for that post was Oct 21 23, unde...

This thread was run at BMWMOA a while back. I was surprised a couple of guys were able to poke new line through without disassembly. I have never h...

The other method of repairing the stripped center stud is to properly install a heli coil. I have done two and with good results. St.