FORUM

Scott Fleming
Scott Fleming
@13807
Active Member
Joined: 08/24/2020 18:19
Last seen: 10/27/2024 07:02
Topics: 2 / Replies: 10
Reply
R100RS, R90S rear brake master cylinder

Have you tried bench bleeding the master cylinder. It is a decent functionality check. The you tubes have several videos.

5 years ago
Reply
1977 R100/7 Headlight Switch issues

If your headlight stays on when the Ignition is off, then you "bridged" the connection with a constant hot 12 volt source, and that should be a red wi...

5 years ago
Reply
R75 instrument housing eye-lids

I got a set from the KatDash web site. I have not installed them yet but they appear to be good. SF

5 years ago
Topic
Replies: 6
Views: 1106
Reply
'76 R90/6: directional signal wiring problems

It is usually the last thing that you did before the problem occurred. Have you checked the throttle area wiring for shorts and bad connections. A...

5 years ago
Forum
Reply
Front brake switch question R100/7

Jcrife, I'm not sure if you are inquiring about an issue with an annoying always on dash light. In particular the light for the brake fluid level. I h...

5 years ago
Forum
Reply
Front brake light switch

It reads like your switch is working correctly and the lever is not fully retracting. It may be time for a master cylinder rebuild, it could just nee...

5 years ago
Forum
Reply
led headlight upgrade

This is what I've been using for the past 7 months. It has a distinct high and low beam. No high temp issues. Headlamp: Motoled 12V 20W x 2/2000LM Mot...

6 years ago
Forum
Reply
Wheel bearings - 1983 R100

ABC632, have a look at the info here. I had a spun race in my rear snowflake. I wouldn't have know anything about it without reading through this, and...

7 years ago
Forum
Reply
1991 r100rt speedo or tach issue

I had a similar issue with my 1980 R80. It had a 34/11 final drive, but the tach read higher than it should have and that was most noticeable when I w...

7 years ago
Reply
Stripped drive shaft drain plug

MotoPhoenix video on the thread repair link below. I was able to remove a stripped final drive plug by prying it up with a screw driver and simul...

7 years ago
Topic
Replies: 3
Views: 4332

Advertisement

Scroll to top