Glad that worked out for you. Good luck!

I did take a look around for the plio-bond, but to no avail...Did, however, find that Gorilla makes a double sided tape as well...I'll do that task af...

You make a good point: #7 may come from BMW with adhesive already applied. On both of my bikes, there's a rubber pad that sits in place of #7, probab...

Thanks Wobbly #7 in the diagram is a rubber mounting pad. There's got to be a recommended adhesive for this, but I don't find reference to it anywhe...

Yeh, sorry Wobbly - Drive-ability was the wrong word here: (I tend to make up words that only make sense to me) I was concerned about the ability to ...

Hey Wobbly (is that a reference to a SWB /5?) So whaddaya think? Green loc-tite 'em and go for it, or is the no heat drive-ability a problem warranti...

Well, I'm glad I happened across this thread. So thanks guys. The tubes look ok so I wasn't going to do anything with them, but out of curiosity, I c...

Hey mark999 - what did you end up doing? I have my top end apart and am interested in the answer to that as well.

Thanks ya guys. I couldn't help it: I pictured what a squirt of PJ1 Black Label would do in those housings...Even so, couldn't be any worse than the ...

Ok I ended up using some EP moly on the mechanism and WD40 for the "cables" If anyone is curious, I'll post long-term results..

I wish I had the short answer...But I found the long answer to testing my diode board here: Good luck!